Skip to content

Essential Steps For Professional Embroidery On A Gildan Jacket

Needle and Thread Selection

The Sharp Point Needle

Sharp-point needles perform best when you work on woven panels of a Gildan jacket, such as chest patches, woven labels, or structured collars, because their slim tip cleanly pierces tight weaves without displacing fibers. You should match needle size to fabric weight and thread diameter; for many cotton or poly-cotton jackets a mid-range size like 75/11 or 80/12 often provides a good starting point, while heavier canvas patches may call for a 90/14. Inspect stitch quality on a hooped scrap of the exact jacket fabric, looking for tidy satin edges and minimal pull-through; when stitches sit flush and the fabric surface remains smooth you have the correct point and size. Keep a small selection of sizes on hand so you can swap quickly between lightweight and heavyweight components.

You will notice problems such as skipped stitches, snagging, or fuzzy holes when the needle tip is inappropriate for the substrate, so perform a quick visual check before long runs. Run a short, high-density sample with the actual design file to confirm that the sharp point produces crisp lettering without thread catching or excessive needle heat. If you see burrs or flattened tips under magnification, replace the needle immediately, because a compromised point increases thread breakage and fabric damage. A practical habit is to change needles between large jobs or after a set number of stitching hours, and to keep a log of which sizes work best on each jacket type.

Selecting High Tensile Thread

Thread with higher tensile strength reduces breakage during dense fills and on outerwear that sees regular laundering, so you should favor polyester or bonded polyester variants designed for commercial embroidery. Choose weight according to stitch type; 40-weight polyester is a common balance for durable logos and crisp satin outlines, while lighter weights handle intricate details more cleanly. Consider the finish, because bonded or waxed coatings decrease abrasion from the needle eye and tension disks, resulting in fewer stoppages during long production runs. Test thread colorfastness on a swatch and launder it in the same way customers will, ensuring hue retention and minimal bleeding when the jacket is washed or dry-cleaned.

You will reduce wasted time by standardizing thread choices for similar jackets, for instance using a single high-tensile polyester family for all hooded fleece orders. Inspect spools for consistent winding and avoid low-quality reels that slip on the stand, as inconsistent pay-off increases tension fluctuations and breaks. Keep spare spools of your go-to tensile family in core colors to prevent substitutions that impact stitch performance, and document preferred thread brands and types next to production files so machine operators select the correct tensile option without guesswork.

Adjusting the Bobbin Tension

Bobbin tension directly affects stitch balance, so you should learn to recognize the visual cues of misadjustment: loops on the underside indicate overly loose bobbin tension, while visible bobbin thread on the top suggests the bobbin is too tight relative to the top thread. Begin adjustments by confirming the bobbin is wound evenly and seated correctly in the case, then make very small changes, because tiny turns of the case screw can produce noticeable differences in stitch appearance. Always perform a sample stitch on the same hooped section of the jacket you will embroider, because sandwiching and fabric stretch alter the effective tension compared with loose tests on a flat piece of material.

You will find it helpful to keep a marked reference for each machine and jacket combination, recording the final bobbin screw position after a successful test, which speeds repeatability between runs. Clean the bobbin area routinely, since lint buildup from fleece or towel-lined jackets alters the mechanical friction that sets tension and leads to inconsistent stitches. If the bobbin tension refuses to settle, swap to a freshly wound bobbin and re-test, and consider minor top-tension adjustments only after establishing a stable bobbin baseline on the exact jacket fabric and hooping configuration.

You may also like